In-Out Conduit Idler is designed to increase the efficiency and sensitivity of a Pull-Pull Conduit System. Engineered with 6” sheaves and three holes to accept Edson’s Conduit End Fittings, the idler makes wire alignment with the sheave automatic. It is recommended that these idlers be used at major load points in engine compartments to allow the steering cable to run over a sheave when being routed aft. Required on center cockpit pull-pull systems over 39’ (12 m).
(Sold without Pull/Pull Conduit and fittings)
Edson’s #962-6AL In-Out Conduit Idler with 6" Sheave Key Features:
- Designed to increase the efficiency and sensitivity
- 6" Sheave constructed of anodized Aluminum
- Housing constructed of Anodized Aluminum
- Fitting thread size of 7⁄8”-9
