Standard Clutch and Throttle Control - 6-7/8"
Edson’s Standard Clutch and Throttle Control features matching stainless control handles which are conveniently located on each side of the pedestal and are clearly marked for “Forward” and “Reverse”, “Fast” and “Slow”. For precision speed control there is a Throttle Friction Adjustment Screw inside the housing.
For use only with Edson # 334, 335, 336 and 337 Pedestals with 6-7/8" diameter top.
This control is easy to install and can be used with any transmission that uses 33 Series (Edson #734) cables such as: Hurth and Borg Warner Velvet Drive Transmissions typically found on Universal, Ford Lehman, Yanmar and Westerbeke engines.
This control should only be used where pulling on the clutch cable end engages the transmission in forward gear. If the opposite occurs, the #816 should be used.
#870ST Engine Control includes Clutch and Throttle Control Housing, Stainless Handles, Clevises, Cable Holder, and all necessary hardware.
EB396 - Engine Control Instructions (#870, #816, #751) - Manual
EXTREMELY FAST SHIPPING, PERFECT REPLACEMENT
The controls replaced a 1984 vertical clutch control which I found cumbersome to operate. The fit was perfect. Shipping (normal shipping selected) was only two days, which really surprised me. Good job Edson!